Hex Bolt Metric Class 10.9 UNC 10.9 Pitch 3.50

Hex bolt M30 class 10.9 pitch 3.50is a hex head bolt for machinery joints, loaded equipment, bases and structures where the design requires higher strength that class 8.8. At TECTUL it is quoted per unit and by actual available size, cross-checking diameter, length, pitch, material and standard before confirming price. This reference is differentiated by class 10.9 in M30 pitch 3.50, not an 8.8 or an ASTM A490 inch-thread; therefore, it should not be replaced with a similar related item only because it has a hex head. The material reported for the lot is heat-treated carbon steel. For class 8.8 and 10.9, selection is based on ISO 898-1 as the reference for mechanical properties; for DIN 933, DIN 960 or DIN 961, full, partial or fine thread geometry is validated against the drawing. For ASTM A325, A490 or A394 bolts, the project standard defines the bolt, nut, washer and assembly. We do not publish single load or torque values because they depend on lubrication, nut, washer, thread condition, grip length and engineering criteria.

Installation recommendations

• Confirm that the nut has the same diameter, pitch and compatible class before tightening.
• Clean threads, holes and bearing surfaces before assembly to avoid false tightening.
• Do not mix metric thread with UNC or UNF; if in doubt, compare against a sample or drawing.
• Apply the torque or tightening method defined by engineering, considering lubrication and coating condition.
• Check grip length and remaining thread so the joint clamps on the parts, not on the thread end.

We dispatch to Bogotá, Medellín, Cali, Barranquilla and all of Colombia. Request a quote via WhatsApp for this hex bolt m30 class 10.9 pitch 3.50, indicating size, quantity, pitch, finish and whether you need a compatible nut or washer.