3/8 Short Driveshaft Clamp

The 3/8 short driveshaft clamp is a carbon steel U clamp used for fastening and replacement in driveshaft assemblies that work with nominal diameter 3/8 and require a version with lower useful height. It is sold by unit and corresponds to inch thread, so compatibility with nuts and housing must be checked before installation. This reference differs from the 3/8 long driveshaft clamp because it is intended for more compact spaces; it also differs from 5/16 clamps because it uses a larger diameter and should not be selected only by appearance. It is a common option for maintenance purchases where the goal is to restore driveshaft fastening without improvising with generic bolts. To quote with lower risk of error, confirm whether the required spare part is 3/8 short, 3/8 long, 5/16 short or 5/16 long.

Selection guide

• Use this reference when the assembly requires a 3/8 clamp in short version.
• If you need greater thread reach, compare with the 3/8 long driveshaft clamp.
• Do not change to 5/16 if the housing was designed for 3/8.
• Validate the thread, pass-through width and available height with the removed part.

Installation recommendations

• Check that the clamp does not enter forced or remain tilted in the housing.
• Use nuts in good condition and compatible with inch thread.
• Tighten uniformly to prevent one side from carrying more load than the other.
• Do not reuse a fatigued, bent clamp or one with damaged threads.
• Confirm that there is no contact with other parts during rotation.

We dispatch to Bogotá, Medellín, Cali, Barranquilla and all of Colombia. Request a quote via WhatsApp for the 3/8 short driveshaft clamp indicating quantity, destination and reference of the part to be replaced.